![]() The next thing I can think of to try is to reinstall the BE software and recreate all the jobs. I have gone through all of my selection lists and backup job configuration settings and find nothing that should be causing the jobs to miss their scheduled run times. I have ran all available diagnostics on my tape drive that BE backs up to and all tests completed successfully without any problems with the tape drive found. ![]() So the jobs are for some reason, missing their scheduled availability window. There may not have been any destination devices available during the window, or the job may have been submitted to run when the window was closed. Every job after this particular one has failed with the following error:Įrror : e000e020 - The job was scheduled to run, but the availability window closed before the job could start. I have followed the link in the error log and wasn't able to figure out any resolution for the failed jobs. Selection list name : System_State-DomainSharesĮrror : e00084c8 - The backup storage device has failed.įor additional information regarding this error refer to link V-79-57344-33992 ![]() The error that started all the failed jobs read as follows: So I've been getting a lot of failed backup jobs recently using Backup Exec 2010 that we purchased a a little over two years ago. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |